Also in 1999, we commissioned a fitting video. This is supplied to contractors and is included in our DIY packs. The latter are in boxes of 10 or 20 panels which include special fixing tape. The video has made fitting much easier for our buyers. We were very conscious that panels should be fitted properly to provide maximum benefit. Panels are fitted by many councils as a matter of course since 1993. Sometimes we are required to supply, fabricate and fit them; sometimes supply them fabricated to suit radiator heights with fixing tape appled to panels. Often they are installed when other heating works are undertaken or or as a standalone operation for energy efficiency. We have been supported in regard to our Radmate DIY panel packs by Efficiency Advice Centres and Local Authorities throughout the UK. Work has been in regard to municipal, Council Housing and Sheltered Accommodation. We have also been involved in job creation schemes. In June 2000 we obtained independent test results via the Energy Saving Trust from from (Stanger - part of Tarmac Group) which established that savings of around 12% applied of to - one Degree plus 2% savings. The best way to make your sad rads glad rads is by application of our Radmate Radiator Insulation and Convection panels to the walls behind radiators. Radmate radiator panels are not a silly size, making handling and working with them simple. The standard panel is 550mm high x 440mm wide and fits standard sized radiators. It is also easily fabricated to suit all radiator heights and width. In almost all cases they can be fitted without radiator removal. Testing was carried out through the energy saving trust which established that application delivers 1 degree C of extra heat and savings of 1.9%. If the additional heat is not required this equates to 11.9% in fuel cost savings and 134kW hours per annum per square metre installed, irrespective of the wall to which fitted.